My keyboard! She’s been my beautiful girl since May 2019, had an internal upgrade but caps and switches have been relatively unchanged.
Switches are 67g Tealios lubed with Tribosys 3204, stabs are genuine Zeal stabs lubed with grease and Krytox 205g0, and it’s all sitting on a brass plate, all on a KBDfans DZ60 RGB-ANSI PCB.
The case is a KBDfans Rose Wood and the keycaps are the Akko World Tour Tokyo.
Long boi is long!!! #wideputin
Not nearly as long as it will be once the track pad and case are on it
Very unique. Perfect for a shallow desk!
Whoah, is the case wood? Walnut?!
It sure is KBDfans GH60! I was impressed with the quality.
Emergency sticker bomb KBD75! I bought a Keyboardbelle KBD75 case a long time ago from Keyboardbelle, but when I went to put the soldered board into the case it was too small by a few mm on each side! No way it was fitting, even with sanding.
This was a puppy build for my niece turning 12, so I got the saw and drill out and made a wooden base and sticker bombed it just in time for her birthday.
Phew.
oof, could you sand/file it down to make it fit?
Sadly not. Sanding down 2mm on each side would have been brutal and I don’t think it would look very good.
Hand wiring?
Nope, it is the Nightmare from Keyhive.
Aha, thought you had a nightmare putting it together.
Cool board. =)
Haha, it was a little bit. Thanks
I found a setup that I am in love with, and plan on leaving on the desk for a while. It’s a good blend of ergo and functionality. Since I work in FinTech, the num pad is essential for work most days.
Quefrency V2 PCB and FR4 plates
P3D carbon fiber infused PLA 3D printed case
NK creams (INVYR stems & 60G Springs) lubed with 205g0
Durock screw in stabs
MT3 Susuwatari doubleshot ABS keycaps
Rama Works M10-C
Hot swap PCB
Gateron Yellows w/ deskey films, lubed w/ 205g0
MT3 Susuwatari doubleshot ABS keycaps